Product information

We manufacture Gypsol binder for anhydrite flowing screeds in quality-assured Readymix facilities throughout the UK. Gypsol screeds are also available in specific locations from volumetric on-site mixing systems.

What we do

Gypsol screed is made from our high-quality Gypsol anhydrite binder, specially selected sands, and clean water. Therefore, it offers the user a simple and effective floor-screeding solution for floating, unbonded, or fully bonded applications where you use a subsequent floor covering.

Benefits of using Gypsol

Using Gypsol Classic will benefit your screed floor because of:

  • Rapid application
  • Thin Screed sections
    • 40mm Floating Commercial
    • 35mm Floating Domestic
    • 30mm Unbonded
    • 25mm Bonded
    • 25mm cover to underfloor heating pipes
  • Fast drying
    • 28 days natural drying*
    • 13 days forced drying*
  • Rapid commissioning of underfloor heating
    • Underfloor heating can be commissioned and run after just seven days
  • No reinforcement nor fibres required
  • No curing agents required
  • Fully self-compacting and high density
    • Offers 80kg/m2 density at just 40mm
  • Rapid return to service of work areas
    • Foot traffic after only 48 hours
    • Full loading after just seven days
  • Assured high strength
    • Minimum Ca C25 – F4

*Independently tested and based on 50mm depth at 20˚C and 60% RH. Complete test data is available on request.

Packaging Gypsol Classic

LKAB Minerals Gypsol Classic screed is available from all Readymix and volumetric screed producers who stock Gypsol Binder.

Sustainability

LKAB Minerals recently had an EPD completed. Click below to see the results.

Environmental Product Declaration

Completed in accordance with ISO 14025 and EN 15804:2012+A2:2019, the EPD report found the following total of kg of CO2 per tonne:
• Gypsol binder: 91.7
• Gypsol Complete binder: 108

Click here to see the full report

Gypsol Screed Product Range

The below screeds are available from ready-mix companies.

Gypsol ClassicOur general-purpose screeding system. The most commonly used material in our range.
Gypsol RapideA self-compacting, self-smoothing, fast-drying floor screed using Gypsol Complete binder.
Gypsol HTC
(High Thermal Conductivity)
A screed made for use with underfloor heating and cooling systems.
Gypsol TS-15An ultra-thin screed for bonded and un-bonded applications at a minimum depth of 15mm.
Gypsol TS-20 thin screed suitable for bonded and un-bonded applications down to a 20mm minimum depth.
Gypsol TimBRESpecially formulated and tested for use in timber frames and over timber-supported floors, including acoustic conditions.
Gypsol XSExtra strength material for use in heavy-duty applications, where loading is likely to be higher than normal.
Gypsol SummitParticularly fit for screeds pumped over very long distances or high buildings of 10 stories and above.
Gypsol ModularDesigned for use in modular construction to allow early movement of units, also for a lightweight steel frame and Lewis Decking.